3
• CHECK DAMAGED PARTS – Before
further use of the appliance, a guard or
other part that is damaged should be
carefully checked to determine that it will
operate properly and perform its intended
function. check for alignment of moving
parts, binding of moving parts, breakage of
parts, mounting, and any other condition
that may affect its operation. a guard
or other part that is damaged should
be properly repaired or replaced by an
authorized service center unless otherwise
indicated elsewhere in this manual.
• DO NOT immerse appliance in water or
squirt it with a hose. do not allow any
liquid to get inside it. If appliance does get
wet, allow to dry for a minimum of 48 hours.
• DO NOT store the appliance on or
adjacent to fertilizers or chemicals.
• DO NOT clean with a pressure washer.
• Keep guards in place and in working order.
• Keep hands and feet away from cutting area.
• do not charge appliance in rain, or in
wet locations
WARNING:
do not use appliance if
the switch trigger does not turn the
appliance on or off. any appliance that can
not be controlled with the switch trigger is
dangerous and must be repaired.
WARNING:
some dust created by this
product contains chemicals known to the state
of california to cause cancer, birth defects or
other reproductive harm. some examples of
these chemicals are:
• compounds in fertilizers
• compounds in insecticides,
herbicides and pesticides
• arsenic and chromium from
chemically treated lumber
to reduce your exposure to these
chemicals, wear approved safety equipment
such as dust masks that are specially
designed to filter out microscopic particles.
• The label on your appliance may include
the following symbols. The symbols and
their definitions are as follows:
V ..................volts
mW..............milliwatts
nm ...............wavelength in nonometers
A ..................amperes
Hz ................hertz
W .................watts
min ..............minutes
or AC ......alternating current
or DC ...direct current
no ................no load speed
................Class I Construction
(grounded)
................earthing terminal
...............safety alert symbol
................Class II Construction
(double insulated)
.../min or rpm...revolutions or
reciprocation per minute
................. Use proper respiratory protection
.................Read instruction manual before use
................Use proper eye protection
...................Use proper hearing protection
1. Variable speed trigger
2. Handle
3. Lock off button
4. Battery
5. Charge indicator
6. Auxiliary handle
7. Height adjust locking
clamp
8. Trimmer head
9. Head rotate button
10. Edge guide
11. Guard
12. Spool housing
13. Spool cap
FUNCTIONAL DESCRIPTION
8
9
7
3
2
11
1
12
10
6
13
4
5
