9
- Switch the UV light (13) on by pressing the
button (12).
- To switch the UV light (13) off, press the
button (12) again.
- Position the jig saw over the cutting line (19).
Viewing from directly above the jig saw,
the line of cut will be illuminated (20) by the
UV light (13) and can be easily followed.
highlighter Pen Storage (figure I)
- The highlighter marking pen (14) stores in
the pen holder (15).
- The pen holder (15) can be opened and
attached anywhere on the cord (21) as shown
in
figure I
.
- To move the pen holder, unlock the hinge
and open the holder.
- Remove from cord and place anywhere up
or down the cord.
NOTE:
Should you need to replace the
highlighter marking pen (14) it can be
replaced with a standard yellow highlighter
found at office supply stores (fine tip
recommended).
Connecting a vacuum cleaner to the tool
A hose adapter (not supplied) is available
at extra cost through your nearest Black
& Decker service center. Insert the hose adapter into the opening at the back of the saw.
Connect a vacuum cleaner hose (not supplied) to the hose adapter.
hints for optimum use
Sawing laminates
As the saw blade cuts on the upward stroke, splintering may occur on the surface closest
to the shoe plate.
- Use a fine-tooth saw blade.
- Saw from the back surface of the workpiece.
- To minimize splintering, clamp a piece of scrap wood or hardboard to both sides of the
workpiece and saw through this sandwich.
Sawing metal
- Be aware that sawing metal takes much more time than sawing wood.
- Use a saw blade suitable for sawing metal.
- When cutting thin metal, clamp a piece of scrap wood to the back surface of the
workpiece and cut through this sandwich.
- Spread a film of oil along the intended line of cut for easier operation and longer blade
life. For cutting aluminum, kerosene is preferred.
wARNING:
fire hazard. Do not use vacuum adapter when cutting metal.
Metal
filings are hot and may cause a fire.
i
15
14
21
h
12
20
13
19
20
13
