Black & Decker KG750, Original Instructions Manual

Page: 12 / 43

12
ENGLISH
•
Place the disc (11) onto the spindle (5) as
shown (fig. B). If the disc has a raised centre
(12), make sure that the raised centre faces
the inner flange.
•
Make sure that the disc locates correctly on
the inner flange.
•
Place the outer flange (13) onto the spindle.
When fitting a grinding disc, the raised centre
on the outer flange must face towards the
disc (A in fig. C). When fitting a cutting disc,
the raised centre on the outer flange must
face away from the disc (B in fig. C).
•
Keep the spindle lock (3) depressed and
tighten the outer flange using the two-pin
spanner (14) (fig. D).
Removing
•
Keep the spindle lock (3) depressed and
loosen the outer flange (13) using the
two-pin spanner (14) (fig. D).
•
Remove the outer flange (13) and the disc
(11).
Fitting and removing sanding
discs (fig. D & E)
For sanding, a backing pad is required. The
backing pad is available from your Black &
Decker dealer as an accessory.
Fitting
•
Place the inner flange (10) onto the spindle
(5) as shown (fig. E). Make sure that the
flange is correctly located on the flat sides of
the spindle.
•
Place the backing pad (15) onto the spindle.
•
Place the sanding disc (16) onto the backing
pad.
•
Place the outer flange (13) onto the spindle
with the raised centre facing away from the
disc.
•
Keep the spindle lock (3) depressed and
tighten the outer flange using the two-pin
spanner (14) (fig. D). Make sure that the outer
flange is fitted correctly and that the disc is
clamped tightly.
Removing
•
Keep the spindle lock (3) depressed and
loosen the outer flange (13) using the two-pin
spanner (14) (fig. D).
•
Remove the outer flange (13), the sanding
disc (16) and the backing pad (15).
Use
Warning! Let the tool work at its own pace. Do
not overload.
•
Carefully guide the cable in order to avoid
accidentally cutting it.
•
Be prepared for a stream of sparks when the
grinding or cutting disc touches the
workpiece.
•
Always position the tool in such a way that
the guard provides optimum protection from
the grinding or cutting disc.
Switching on and off
•
To switch on, slide the on/off switch (1)
forward. Note that the tool will continue
running when you release the switch.
•
To switch off, press the rear part of the on/off
switch.
Warning! Do not switch the tool off while under
load.
Hints for optimum use
•
Firmly hold the tool with one hand around the
side handle and the other hand around the
main handle.
•
When grinding, always maintain an angle of
approx. 15° between the disc and the
workpiece surface.