English
7
Figure J
Figure K
Figure L
• Attach the steam glove
9
as shown in the "Attaching
the hose and steam glove" section.
nOTE:
The SmartSelect
TM
dial is disabled when the steam
glove is attached.
Attaching a cleaning pad
1. Insure steam glove is cool and not attached to hand-held
steam cleaner.
2. Fit a steam glove cleaning pad
13
to the steam glove
9
by attaching the velcro strips
33
on the back side of the
cleaning pad, to the velcro pads
34
on the underside of
the steam glove (figure M).
3. Press down firmly.
4. To use, follow instructions under hand-held steam
cleaning.
WARNING:
Do not use the steam glove without a
cleaning pad in proper position.
Figure M
33
34
9
13
Hand-held steam cleaning
1. Attach the required accessory from the steam mop
body.
nOTE:
The unit will not produce steam unless an accessory
hose is fitted.
2. Plug hand-held steam cleaner electric cord into the
outlet.
3. Press the ON/OFF button
1
. It takes approximately 15
seconds for the hand-held steam cleaner to heat up.
• When you have finished using the hand held steam
cleaner, turn it ‘OFF,’ and unplug it. Wait until it cools
(approximately five minutes) before reattaching to
steam mop body.
Hints for optimum use
General use
CAUTION:
Never use the steam mop without first
attaching a cleaning pad.
WARNING:
It is important to monitor the water level
in the water tank. To refill the water tank and continue
to sanitize/ clean, see Filling the Water Tank section.
nOTiCE:
Never leave the steam mop in one spot on any
surface for any period of time. Do not store with a wet pad
as this can damage your floor. Make sure the steam mop is
turned off when not in use.
• Always vacuum or sweep the floor before
using the steam mop.
• The easiest way to use the steam mop is to tilt the
handle to a 45˚ angle and clean slowly, covering a small
area at a time.
• Do not use chemical cleaners with your steam
mop.
To remove stubborn stains from vinyl or linoleum
floors, you can pre-treat them with a mild detergent and
some water before using the steam mop.
After use
• Wait until the steam mop cools down. (approximately
five minutes)
• Unplug the steam mop from the wall outlet.
• Empty the water tank.
• Remove the cleaning pad (
13
or
18
) and wash it so
that it is ready for the next use. (Take care to follow the
wash care instructions printed on the cleaning pad).
• Switch the steam mop off by turning the SmartSelect
TM
dial to off and pressing the ON/OFF button.
nOTE:
The top cord hook rotates to easily release the cord
for the next use.
nOTE:
With the handle tube in the upright position, the
cord neatly wrapped around the cord hooks your steam
mop will stand on its own for storage. Alternatively there
is a hanging bracket built into the hand grip which will
allow your steam mop to be hung from a suitable hook on
the wall. Always ensure that your wall hook is capable of
supporting the weight of the steam mop safely.