Black & Decker FSM1625, Manual

Page: 6 / 16

6
ENGLISH (Original instructions)
(13), ensure that the water jug is firmly seated.
Attaching a cleaning pad (Fig. D)
Replacement cleaning pads are available from your Black &
Decker dealer:- (cat. no. FSMP20-XJ).
Steam head cleaning pad - cat. no. FSMP20-XJ).
Delta head cleaning pad - cat. no. FSMP30-XJ.
u
Place a cleaning pad (6 or 7) on the floor with the‘hook &
loop’ side facing up.
u
Lightly press the steam mop down onto the cleaning pad
(6 or 7).
Caution! Always place your steam mop on the resting mat (8)
with the handle (4) in the upright position when stationary and
make sure the steam mop is turned off when not in use.
Removing a cleaning pad (Fig. E)
Caution! Always wear suitable shoes when changing the
cleaning pad on your steam mop. Do not wear slippers or
open toed footwear.
u
Return the handle (4) to the upright position and turn the
steam mop ‘OFF’.
u
Place the steam mop on the resting mat and wait until it
cools down. (approximately five minutes)
u
Place the front of your shoe onto the cleaning pad removal
tab (15) and press down firmly.
u
Lift the steam mop up off the cleaning pad.
Caution! Always place the steam mop on the resting mat (8)
with the handle (4) in the upright position when stationary and
make sure the steam mop is turned off when not in use.
Attaching the carpet glider (Fig. F)
u
Place carpet glider on the floor.
u
Lightly press the steam mop down onto the carpet glider
(12) until it clicks into place.
Caution! Always place the steam mop on the resting mat (8)
with the handle (4) in the upright position when stationary and
make sure the steam mop is turned off when not in use.
Removing the carpet glider (Fig. F)
Caution! Always wear suitable shoes when changing the
carpet glider on your steam mop. Do not wear slippers or
open toed footwear.
u
Return the handle (4) to the upright position and turn the
steam mop ‘OFF’.
u
Place the steam mop on the resting mat and wait until it
cools down. (approximately five minutes)
u
Place the front of your shoe onto the carpet glider removal
tab (16) and press down firmly.
u
Lift the steam mop up off the carpet glider (12).
Caution! Always place the steam mop on the resting mat (8)
with the handle (4) in the upright position when stationary and
make sure the steam mop is turned off when not in use.
The Delta Head (Fig. G)
This Steam Mop incorporates a built in delta head which
enables you to access into tight corners and narrow gaps.
Caution! Always wear suitable shoes when accessing the
delta head on your steam mop. Do not wear slippers or open
toed footwear.
u
Return the handle (4) to the upright position and turn the
steam mop ‘OFF’.
u
Place the steam mop on the resting mat and wait until it
cools down. (approximately five minutes)
u
Place the front of your shoe onto the steam head removal
tab (18) and press down gently.
u
Lift the delta head (17) up off the steam head (5).
u
Fit the delta head cleaning pad to the bottom of the delta
head.
Note: Remove the cleaning pad before re-fitting the delta
head to the steam head.
u
To refit the delta head, place the tip of the delta head into
the steam head then press down firmly ensuring that the
delta head clicks into place.
Caution! Always place the steam mop on the resting mat (8)
with the handle (4) in the upright position when stationary and
make sure the steam mop is turned off when not in use.
Filling the water tank (Fig. H)
The watertank on your steam mop is removable for convi-
enient and easy filling.
This Steam Mop incorporates an anti-calc system to help
prolong the life of the system.
Note: Fill the water tank with clean tap water.
Note: In areas of very hard water, the use of de-ionised water
is recommended.
u
Remove the water tank (3).
u
Open the filler cap (19) by lifting it up.
u
Fill the water tank (3) with water.
Warning! Your water tank has a 0.46 litre capacity. Do not
over fill the tank.
u
Re-fit the filler cap (19).
u
Re-fit the water tank (3).
Note: Ensure the filler cap is firmly secured.
Use
Important! This unit will kill 99.9% of bacteria & germs when
used in accordance with this manual and with the micro fibre
pad fitted and a continuous run time of 90 seconds.
Switching on and off
u
To switch the appliance on, press the ON/OFF button (1).
It takes approximately 15 seconds for the steam mop to
heat up.
Note: When the steam mop is first turned on the water res -
ervoir will glow red. Once the steam mop is ready to use the