6
5. To use the large food chute place the foods to be processed into the large opening of
the food chute. Place the multifunctional feed chute with the food pusher in place over
the food and guide the food through the chute.
Important: The large food chute is best used with the slicing/shredding disc in place.
CONTROLS
The controls are located on the front of the base. Press LOW, HIGH or 0/(P) to select a
function. (See directions below.)
0/(P) (STOP/PULSE)
• Processor should be stored in 0/(P) position and unplugged when not in use.
• Use 0/(P) for short processing tasks.
• The 0/(P) button must be pressed and held for the appliance to operate. When released
the appliance will stop. Do not use the 0/(P) (stop/pulse) button longer than 2 minutes.
• The motor of the processor runs as long as this button is held down. Press the button
down and then release; allow the blades to stop running and the food to fall to the
bottom of the workbowl before pressing again.
• Pulsing gives better control when chopping, mincing, mixing and blending foods.You can
control the size of the foods from coarse to fine.
LOW OR HIGH
• When these functions are selected the processor runs continuously until the 0/(P)
button is pressed.
• These speeds are used for chopping, blending, dressings, sauces and making batters
and doughs.
HOW TO CHOP IN THE LARGE WORKBOWL
The chopping blade is used to coarsely or finely chop, mince, mix and puree foods to a
smooth consistency. Use the workbowl to chop fresh and cooked fruits and vegetables,
cooked and raw meats, fish and poultry; to make sauces, dressings and salsas; to make
pastry, cookie and cracker crumbs.
1. Lock workbowl with post with interlocking safety latch in place into position
(see Illustration A)
.
2. Hold large chopping blade by center shaft and insert onto center post
Note
(this side up) on blade attachment
(C)
.
Note:
The blade attachments are very sharp. Use caution when handling
and storing.
3. Place food in workbowl.
4. Place cover on workbowl and lock into place by rotating cover clockwise
(See Illustration B)
.
5. Place the multifunctional feed chute and food pusher in place in food chute. Never use
your fingers to direct food through chute.
6. Press LOW or HIGH button.
Note:
Process foods no more than a few seconds at a time. Pulsing produces excellent
results and offers greater control.
7. To add food or liquid while processor is running, remove food pusher and insert through
the multifunctional feed chute. Replace food pusher in chute.
Important: Be sure chopping blade has completely stopped spinning before
removing cover from processor.
8. When finished, press the O/(P) button and allow blades to stop revolving before
removing cover. Twist cover to remove.
9. To unlock workbowl, turn it clockwise and lift off base.
C