Black & Decker Dustbuster SVJ520BFSP, Original Instructions Manual

Page: 9 / 12

9
ENGLISH (Original instructions)
Even with the application of the relevant
safety regulations and the implementa-
tion of safety devices, certain residual
risks can not be avoided. These include:
u
Injuries caused by touching any
rotating/moving parts.
u
Injuries caused when changing any
parts, blades or accessories.
u
Injuries caused by prolonged use
of a tool. When using any tool for
prolonged periods ensure you take
regular breaks.
u
Impairment of hearing.
u
Health hazards caused by breathing
dust developed when using your
tool (example:- working with wood,
especially oak, beech and MDF.)
Chargers
Your charger has been designed for a
specific voltage. Always check that the
mains voltage corresponds to the voltage
on the rating plate.
Warning! Never attempt to replace the
charger unit with a regular mains plug.
u
Use your BLACK+DECKER charger
only to charge the battery in the
appliance with which it was supplied.
Other batteries could burst, causing
personal injury and damage.
u
Never attempt to charge non-
rechargeable batteries.
u
If the supply cord is damaged, it must
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
u
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
The appliance/battery must be
placed in a well ventilated area when
charging.
Electrical safety
Symbols on the charger
Read all of this manual carefully before using the
appliance.
#
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
corresponds to the voltage on the rating plate.
$
The charging base is intended for indoor use only.
Labels on appliance
The following symbols appear on this appliance along with the
date code
+
Read all of this manual carefully before
using the appliance
S010Q 23
Only use with charger S010Q 23
Features
This tool includes some or all of the following features.
1. On/off power switch
2. Nozzle
3. Pull out crevice tool
4. Push in brush
5. Dust bowl
6. Power head
7. Charging base
8. Handle on/off power switch
9. Brush on button
10. Handle
11. Chassis release button
12. Main chassis
13. Beater bar unit
14. Beater bar
15. Floor head
16. Beater bar unit release button
Use
Switching on and off (Fig. A)
u
To switch on, press the on/off switch (1) located on the
handle of the Dustbuster
®
, or alternatively on the chassis
handle (8).
u
Press the button again (1 or 8), and the unit goes to a
BOOST mode.
u
To switch off, press the on/off switch (1) or (8).