Black & Decker BWT08THSB, Instruction Manual

Page: 6 / 12

Page 6
INSTALLATION GUIDE
1. Unpack your wine cellar by removing all packaging materials like carton, base,
foams, adhesive tape, etc.
2. Remove all accessories, internal packaging material used to hold shelves, ice tray,
etc. in place.
3. Clean the remains of all adhesive tap used and remove all printed material
supplied.
4. Install the wine cellar in a convenient location away from extreme heat and cold.
Allow sufficient clearance between the wine cellar and side wall so the door(s)
will open without obstruction. Wine cellar is not designed for recessed or built-in
installation.
5. The floor on which the wine cellar should be placed must be flat, hard, solid, and
even. The wine cellar should not be placed on any soft material such as foam,
plastic, etc.
6. To level your wine cellar, use the two leveling legs in the rear and one in the front
left of your wine cellar. Adjust by turning the legs counter clockwise to raise or
clockwise to lower your wine cellar. The door will close easier if the leveling legs
are extended.
NOTE: The foot that is part of the door hinge bracket is not adjustable.
7. The following are recommended minimum clearances around the wine cellar for
proper air circulation:
Sides: 2” (50mm)
Top: 4” (100mm)
Back: 2” )50mm)
Proper air circulation will help your wine cellar work at maximum efficiency.
NOTE: · Allow enough space in the front of the unit to open door to at least 120˚.
OPERATION GUIDE
1. Plug in the wine cooler to power the unit on.
2. Press the ˚C/˚F button to select the temperature display in Fahrenheit or Celcius.
3. You may choose a temperature setting for your wine cooler within the range of 46° to
66° Fahrenheit or 54° to 66° Fahrenheit based on the model you purchased (Refer to
page 5). The temperature of your wine cooler can be set by pressing the up arrow
temperature pad on the exterior of the glass door you can raise the temperature. By
pressing the down arrow
temperature pad on the exterior of the glass door you can
lower the temperature. Once you have completed your set temperature selection, the
temperature readout will revert to the actual temperature.
SET UP & USE