Black & Decker BDCDB18, Manual

Page: 6 / 14

6
ENGLISH
Installing and removing the battery (Fig. B)
Warning! Make certain the vac is switched off before
removing or installing battery.
To install battery pack

Insert battery pack into the vac until an audible click is
heard (Figure B). Make sure battery pack is fully seated
and fully latched into position.
To remove battery pack

Depress the battery release button (6) as shown in Figure
B and pull battery pack out of the vac.
Operation
Warning! This product is for dry pick-up only.

To switch the vac on, slide the on/off switch forward
(Fig. C).

To switch the vac off, slide the on/off switch backward
(Fig. C).
Assembly

Remove the dust bowl (3) by pressing the dust bowl
release button (2) and pulling the bowl down and out
(Fig. D).


Note:
position before use.

To install the dust bowl, place it back onto the front of the
Mounting accessories

The brush tool (8) has a brush that can be used for dust-
ing and upholstery cleaning.

The crevice tool (7) allows for vacuuming in narrow and
hard to-reach places.

To attach an accessory, press the accessory into dust
bowl (3).
Cleaning the product
Warning! Never use this cordless hand vacuum
Note: -
able dust bags, and do not throw it away when the product is
months.
Warning! Maximum dust collection will only be obtained with
out of the product after it is switched off, this indicates that the
bowl is full and requires emptying.


Empty the dust from the bowl and wash if necessary.

using again.
Note:
perform.

The dust bowl can also be washed in warm soapy water
attaching.

Never immerse the product in water. A damp cloth and
soapy water should be used to clean the exterior of the
motor section. Always ensure the product is completely
dry before re-use or storing.
Troubleshooting
Problem Possible Cause Possible Solution
Unit will not start. Battery not installed
properly.
Battery not charged.
Check battery
installation.
Check battery charging
requirements
Battery will not charge. Battery not inserted into
charger.
Charger not plugged in.
Surrounding air
temperature too hot or
too cold.
Insert battery into
charger
until LED appears.
Plug charger into a
working
outlet. Refer to
“Important
Charging Notes” for
more details.
Check current at
receptacle
by plugging in a lamp
or other appliance.
Check to see if
receptacle is
connected to a light
switch which turns
power off when you
turn out the lights
Move charger and tool
to a surrounding air
temperature of above
4,5°C or below
+40,5°C.
Maintenance
Your BLACK+DECKER tool has been designed to operate
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
Your charger does not require any maintenance apart from
regular cleaning.