7
Tip of the sanding base ( Figure 3)
When the sanding base tip is worn, it can be reversed or replaced.
• Remove the screw (3a).
• Reverse or replace the worn part (3b).
• Replace and tighten the screw.
TROUBLESHOOTING
Problem
Possible Cause
Possible Solution
• Unit will not start.
• Cord not plugged in.
• Plug tool into a
working outlet.
• Circuit fuse is blown.
• Replace circuit fuse. (If
the product repeatedly
causes the circuit fuse
to blow, discontinue use
immediately and have
it serviced at a Black &
Decker service center
or authorized servicer.)
• Circuit breaker is tripped.
• Reset circuit breaker.
(If the product
repeatedly causes the
circuit breaker to trip,
discontinue use
immediately and have
it serviced at a Black &
Decker service center
or authorized servicer.)
• Cord or switch is damaged.
• Have cord or switch
replaced at a Black &
Decker service center
or authorized servicer.)
For assistance with your product, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the BLACK & DECKER help line at
1-800-544-6986.
3
3a
3b
