OPERATING INSTRUCTIONS
WARNING:
To reduce the risk of serious personal injury, read, understand and
follow all important safety warnings and instructions prior to using this tool.
Switch
To turn the tool ON, hold it as shown in
figure 1
and push the portion of the
switch (1a) marked "I". To turn the tool
OFF, push the portion of the switch
marked "O".
Operation
Grasp product as shown in
figure 1
and turn it on. Move it in long sweeping strokes
across the surface, letting it do the work. Light pressure is all that is required for sanding,
polishing or scrubbing. Excessive pressure will slow the tool and produce inferior
results. Check your work often, product is capable of removing material rapidly.
WARNING:
Under no circumstances should this product be used near water.
WARNING:
Always unplug product from power supply before any of the following
operations.
Detail Sanding
Your tool is equipped with a teardrop base which allows you to use it on large flat
surfaces and tight spots or corners.
The pad tips may wear unevenly, depending on use. The pads are designed to allow
you to interchange and /or rotate the diamond tip.
Fitting sanding sheets (Figure 2)
• Detach the two diamond-shaped tips from the sanding sheet (2a).
• Hold the tool with the sanding base
facing upwards.
• Place the sanding sheet onto the
sanding base.
The diamond-shaped tip can be
reversed and replaced when worn.
• When the front part of the tip is worn,
detach it from the sheet, reverse it and
press it onto the sanding base again.
• When the whole tip is worn, remove it
from the sanding base and fit a new tip.
6
R
2
2a
1a
1
