Page 14
SET UP & USE
FILTER INSTALLATION
Your air purifier comes with a 4 stage (Pre-Filter, True HEPA H13 Filter, Activated
Carbon Filter, Photocatalyst Filter) Filtration system.
To access the filters:
1.
Remove the front panel by pulling the top outwards with both hands.
2.
If using for the first time, carefully remove each filter and their packaging, and
remove tape from UV lamp from unit.
To reinsert filters:
1.
Replace with new filters in sequence as listed ending with the pre-filter. Ensure
the tabs are facing forward when re-inserting back into the unit.
2.
The pre-filter can be vacuumed or cleaned with a soft brush. Re-insert the pre-
filter by inserting the bottom into the slots first and gently snapping the 2 tabs
into place on top.
3.
Reattach the front panel by aligning the bottom edge first and gently pushing
the top into the original position.
The FILTER REPLACEMENT
indicator light will be flashing red after 1600 hours
of use. The HEPA and CARBON filters should be replaced at the same time. You
may need to replace them sooner if you are using the air purifier in an
environment with poor air quality. If you notice that the filters do not appear
visibly clean, or air purification seems to have decreased, the filters should be
replaced.
WARNING:
Do not run the unit without the filters in place.
Photoresistance
Photo-catalyst filter
Activated carbon filter
True HEPA filter
Pre-filter
The front panel
UV tube
Summary of Contents for BAPUV150
Page 19: ...Page 19 ...
