Page 10
SET UP & USE
Filter Replacement Light
WARNING
: Unplug unit before replacing filters.
After 1600 hours of use, the indicator
located in between the RESET
and
POWER
button will be flashing. Replace the HEPA filter and Activated Carbon
Filter. After the filters have been replaced, touch the RESET button for 5 seconds to
reset. The REPLACE FILTER indicator light will turn off and the other control panel
lights will illuminate.
NOTE:
Refer to CLEANING AND MAINTENANCE section of this manual for
information about how to access and install the filter.
To shut OFF the unit at any time, touch POWER
and it will illuminate red with
other indicator lights off. Unplug the unit.
WARNING:
Do not run the unit without the filters in place.
Using the Remote Control:
Air purifier can be operated using the remote control.
1. To turn the unit on, press the POWER
Button.
2. To operate fan speed low, medium or high, press the FAN SPEED
button.
Continue to press until the appropriate speed is highlighted on the unit.
3. Press SILENT
mode if you would like the fan speed on lowest option.
4. Press AUTO
A
if you would like the fan speed to automatically set according to
the air quality in the room.
5. Press TIMER
if you would like to choose 1, 4 or 8 hour option.
6. Press UV
Lamp if you would like the UV Sensor activated.
7. Press Anion
Function if you would like it activated.
8. Press RESET
after you replace the filters. Hold for 5 seconds.
Summary of Contents for BAPUV150
Page 19: ...Page 19 ...
