
8
JIG SAW / RECIPROCATING SAW MODES (FIGURES F, F1)
The LPS7000 can be used in two different ways:
JIG SAW MODE
- Blade teeth face forward as
shown in
figure F
.
RECIPROCATING MODE -
Blade teeth face
downward as shown in
figure F1
.
The LPS7000 accepts T-shank blades only.
Thin kerf 10tpi or higher blade recommended.
BLADE CLAMP RELEASE LEVER (FIGURE G)
CAUTION: Burn hazard.
Recently used
blades may be hot.
To install blade into saw:
•
Push down on the blade clamp release lever (5)
to its full open position as shown.
•
Insert blade shank (9) from the front.
•
Release the blade clamp release lever (5).
To remove blade from saw:
•
Push down on the blade clamp release
lever (5) to its full open position.
•
Remove blade.
•
Release the blade clamp release lever (5).
WOOD CUTTING
NOTE: Use “T” shank 10tpi or higher, thin kerf blades.
•
Before cutting any type of wood, use clamps or another practical way to secure and
support the workpiece to a stable platform. Holding the work by hand or against your
body leaves it unstable and may lead to loss of control.
•
Place shoe firmly against work to be cut.
•
Switch on saw motor before applying pressure.
•
Whenever possible, the shoe must be held firmly against the material being cut. This will
prevent the saw from jumping or vibrating and minimize blade breakage.
TREE TRIMMING
•
Hold shoe firmly against tree branch. If possible, cut close to the trunk to minimize
movement of the branch.
METAL CUTTING (FIGURE H)
NOTE: Use “T” shank 18-24 tpi metal
cutting blade.
•
In thin gauge sheet metals it is best to
clamp thin plywood to underside of sheet.
This will ensure a clean cut without excess
vibration or tearing of metal.
•
Avoid forcing cutting blade as this reduces
blade life and causes costly blade
breakage.
•
When cutting metal piping, do not cut
directly through the pipe as you would saw
a wooden dowel. Instead, cut around the
circumference of the pipe to avoid pinching
the blade. Only one section of the blade
should be in contact with the pipe.
NOTE:
You should spread a thin film of oil or other coolant along the line ahead of the
saw cut for easier operation and longer blade life. For cutting aluminum, kerosene is
preferred.
PROJECT TIPS
•
Cut only with sharp blades; they cut cleaner, faster and put less strain on the motor
while cutting.
G
H
T
M
F
TM
F1
90547733 LPS7000 Saw 6/11/09 7:21 AM Page 8