5
Lubrication
All ball and sleeve bearings used are factory lubricated to last the life of the
bearings. All needle bearings used received their lubrication from the grease
in the gear case. Clean and relubricate gear case yearly or whenever servic-
ing requires the gear case to be removed. Use type and quantity of grease
shown on Parts Bulletin packed with your tool.
The gear case is removed by removing the three screws from the front of the
tool. If the chuck is too large to permit removal of the two top screws, see
instructions for chuck removal.
Motor Brushes
Your drill uses the B&D CHECKPOINT™ brush system. The tool will stop
when the brushes wear out. This prevents damage to the motor.
IMPORTANT!
To assure product safety and reliability, particularly for double Insulated
tools, repairs, maintenance and adjustment (excluding maintenance
described in this manual) should be performed by B&D service centers or
authorized service centers, using identical B&D replacement parts.
Accessories
Recommended accessories for use with your tool are available at extra cost
from your distributor or local service center.
CAUTION: The use of any non-recommended accessory may be hazardous.
If you need any assistance in locating any accessory call 1-800-9-BD TOOL:
(1-800-923-8665) or contact Black & Decker (U.S.) Inc., Consumer Services
Department, 626 Hanover Pike, P.O. Box 618, Hampstead, MD 21074.
MAINTENANCE
One Year Service/Safety Check
All B&D tools for Industry and Construction are covered under a
service/safety check program where B&D will inspect your tool for safety
and provide necessary maintenance or repairs, including normal wear and
tear parts, for one year, FREE OF CHARGE.
Full Warranty
All B&D tools for Industry and Construction are warranted to be free of any
defects in materials or workmanship. Upon thorough examination of tool,
B&D will repair or replace, at our option, any product that is determined to
be defective.
Conditions
The service/safety check and the warranty do not apply to: repairs made or
attempted by anyone other than an authorized B&D service location; misuse,
abuse, neglect, improper application of the tool; missing parts; or normal wear
and tear (after first year of ownership). Please return the complete unit, trans-
portation prepaid, to any B&D factory owned or B&D authorized service center
location (list provided with tool or see Yellow Pages under “Tools Electric”).
Every B&D tool is of the highest quality.
If you wish to contact us regarding this product, please call toll
free between 8:00am and 8:00pm ET, seven days a week:
1-800-9-BD TOOL
(1-800-923-8665)
154566/1180-220 5/17/02 1:32 PM Page 5
