3
The reversing lever is used to reverse the drill for backing out screws or
jammed bits. It is located above the trigger, shown in Figure 2. To reverse
the drill, turn it OFF and push the reversing lever to the left (when viewed
from the chuck end). To position the lever for forward operation, turn the
drill OFF and push the lever to the right.
Chuck
To insert bit, open chuck jaws by turning collar with fingers and insert
shank of bit about 3/4" into chuck. Tighten chuck collar by hand. Place chuck
key in each of the three holes and tighten in clockwise direction. It’s impor-
tant to tighten chuck with all three holes. To release bit, turn chuck key
counterclockwise in just one hole, then loosen the chuck by hand.
Chuck Key Holder
(May be installed already)
1. Push double hole end of holder through slot in other end of holder
(Figure 3).
2. Slip loop over electric plug and draw loop tight around cord (Figure 4).
3. Push ends of chuck key handle through two holes in end of holder
(Figure 5).
Chuck Removal
1. turn off tool and DISCONNECT FROM POWER SUPPLY.
2. Place chuck key in chuck as shown in Figure 6.
3. Using a wooden mallet or similar object, strike key sharply in a clock-
wise direction. This will loosen screw inside chuck (Figure 6).
4. Open chuck jaws fully. Insert screwdriver (or 3/16" hex wrench if
required) into front of chuck between jaws to engage screw head.
REVERSING
LEVER
TRIGGER
SWITCH
LOCKING BUTTON
Figure 2
Figure 1
Figure 3
Figure 5
Figure 4
154566/1180-220 5/17/02 1:32 PM Page 3
