Rotisserie Oven
Maintenance
31
9. Remove the Wire Racks or Drip Tray and the Dripping Drawer from the oven (refer to Figure 1
above).
10. Clean the Fan Guard, Wire Racks or Drip Tray and Dripping Drawer with mild soap and water
solution or approved cleaner and a sponge. Wipe dry with a clean cloth.
11. Clean in interior oven cavity with mild soap and water solution or approved cleaner and a sponge.
Wipe dry with a clean cloth.
12. Carefully clean the fan blades using a mild soap and water solution or approved cleaner and a
scrub brush. Do not bend or disfigure the fan blades.
13. Clean the outside of the oven with mild soap and water solution or approved cleaner and a
sponge. Wipe dry with a clean cloth.
14. Replace the Fan Guard, Wire Racks or Drip Tray and Dripping Drawer in the oven cavity (refer to
Figure 1 above).
15. Lubricate the gears on the Drive Rotor as shown below with Permatex® Super Lube® Synthetic
Lubricant with PTFE (BKI part number L0200).
16. Reinstall Rotor System as shown below.
Lubricate gear teeth.
STEP 1
Install the Rotor Disks by first
inserting the guide pin into the shaft
center hole. The Rotor Disk with
gears goes on the right side of the
oven. It will be necessary to rotate
this Rotor Disk while pushing in to
engage the gears and the drive hub.
When properly installed there will be
approximately ¼” [6 mm] space
between the Rotor Disk and cavity
side.
STEP 2
Rotate both Rotor Disks so that the
U-shaped slot in the hubs is facing
up and forward as shown. Grasp
the Rotor Shaft with both hands and
insert the ends into the U-shaped
hub slots. The pins in the Rotor
Shaft ends must insert into the holes
in the bottom of the U-shaped slots
in the Rotor Disk Hubs.
STEP 3
Slide the Rotor Shaft Nuts on both
ends of the shaft over the Rotor Disk
hub and tighten by rotating the nuts
clockwise.
ROTOR
GUIDE
PIN