GPH Plus Owner’s Manual 29
SPECIAL CLONING INSTRUCTIONS
It is possible to change Channel 0 values on the Master radio, hold
them in a temporary memory, and download them to the Clone without
actually entering them into the permanent memory of the Master. This
is convenient for sequential identification numbers used to identify a
series of portables in a radio system.
Assuming that the frequencies,
Channel Guard values, and other CH 0 values are common for all
radios in the system, but that the radio identification number should be
unique to each radio, the following method can be used to clone
additional radios for the system:
1.
Program the Master with all frequencies,
Channel Guard values, and Channel 0
values that will be common to all radios.
2. Advance the display to show the ID number
of the master (for example
100
).
3. Press the
[CLR]
key; press
125
. Do not
press the
[ENT]
key. Now 125 is in
temporary memory.
4.
Press
[*]
, connect the cloning cable to the
Clone radio, and download by pressing
[FCN]
. ID number 125 is now stored in the
permanent memory of the clone.
5.
After downloading, press
[CLR]
on the
Master radio. Disconnect the Clone. The
Master radio display will show that
125
is
still being held in the temporary memory of
the master.
6.
Press the
[PRI]
key. This will increment the
ID number one digit to
126
.
NOTE:
Any new number can be entered at
this point by pressing
[CLR]
and
using the keypad to enter the new
number.
7.
Press the
[*]
key. Connect the cloning cable
to the next Clone and download by pressing
[FCN]
.
8. Any number of radios can be coded with
different or sequential ID numbers using this
technique. The ID number in the permanent
memory of the master will remain unchanged
at 100.
PRG ID
125
PRG ID
126
1
2
3
4
5
6
7
8
9
0
*
#
CLR
FCN
PRI
ENT
PRG ID
125
Summary of Contents for GPH Plus
Page 1: ......
Page 35: ...34 RELM Wireless Corp NOTES ...
Page 36: ...GPH Plus Owner s Manual 35 NOTES ...
Page 37: ......
