SAFETY
These steps outline the minimum, basic safety
precautions that must be followed when using this
high voltage probe. Before you use this instrument,
read and thoroughly understand this information.
You must have a thorough understanding of the
hazards that may occur when working with high
voltages and when using this probe. Failure to
follow good safety practices could cause you serious
personal harm, even death. Remember, high voltage
kills if safety precautions are not followed!
1. In addition to these safety instructions, follow
those given by the manufacturer of the device being
checked.
2. Examine probe, make sure it is clean and dry.
Dirt, moisture and grease can provide a creep path
for voltage. If in doubt, wipe with a clean, dry, lint-
free cloth.
3. Check floor in the test area. It must be dry, clean
and free of oil. Never stand on a wet or damp floor.
4. Always connect the alligator clip of the probe to
earth ground before taking any measurements.
5. Examine the entry to your high voltage test point.
Make sure that you are able to bring the probe in
to the test point. Also, make sure the tip is clear of
wires, metal supports and other nearby conductive
surfaces.
6. Verify that you are able to remain clear and
avoid contact with any exposed metal and /or other
conductive parts of the device being checked.
!
