Figure 7.2: Meter Display
Parameter name
Parameter descriptions
V_RANGE
Voltage range setting: press the soft key corresponding to this parameter to set the
voltage range.
A_RANGE
Current range setting: press the soft key corresponding to this parameter to set the
current range.
RUN/HOLD
Run/hold: press the soft key corresponding to this parameter to run or hold the
integral function.
RESET
Reset.
FUNC(w/q/AV)
Selection of the integral function: active power integral (W), current integral (q) and
average active power integral (AV).
LARGE(WP/WP+/WP ,
q/q+/q-, WPAV)
Selection of the item to be displayed in a amplified manner: WP (watt hour, the sum
of positive and minus watt hours), WP+ (the consumption of positive watt hours),
- WP- (the negative watt hours of feedback power), q (ampere hour, the sum of
positive and negative Ampere hours), q+ (the consumption of positive Ampere
hours), q- (the negative ampere hours of feedback power) and WPAV (average
active powerintegral).
START
Integral Start button In the manual start mode, the integral function can be enabled
by pressing the soft key corresponding to this parameter.
STOP
Integral Stop button In the manual stop mode, the integral function can be disabled
by pressing the soft key corresponding to this parameter.
SETUP
Set relevant parameters of integral measurement.
Table 7.1: Integral Measurement Soft Keys
7.2
Introduction of soft keys on the interface
When the “Integ” button is pressed, the initial integral measurement
interface below will appear.
Description of information of integral measurement interface:
7.3
Integral measurement display information
Description of measurement information:
