13
6.2 Manual Operation Mode
In the Manual Operation Mode, once the voltage and current levels have been set, the unit wi11 keep these settings even after unit has been
switched off until further reset.
There are 3 ways to input a setting:
1.
By the
Jog Dial.
2.
By the
UP
or
DOWN
key.
3.
By the
Key Pad.
For any wrong input, e.g. out of specification values, display will show
"OUT OF
RANGE"
FOR ABOUT 3 SECONDS, then returns to
it's previous settings and ready for correct new input.
Manual Setting of Voltage and Current by Jog Dial
1.
To change the voltage setting, just rotate the Jog Dial, no other step is needed.
2.
To change the current setting, press
ENTER
twice, the LCD will show
I-set,
push
for desired value.
3.
Press
ENTER
to confirm your chosen current setting.
Manual Setting of Voltage and Current by Up
&
Down Key
1.
To change the voltage setting, just press the Up & Down Key
,
no other step is needed.
2.
To change the current setting, press
ENTER
twice
,
the LCD will show
I-set
, push the
Up
&
Down
key for desired value.
3.
Press
ENTER
to confirm your chosen current setting.
Manual Setting of Voltage and Current by Key Pad
1.
Press
ENTER
.
Display will show
V -set
and the present voltage setting, key in the desired voltage level.
2.
Press
ENTER
to confirm your chosen voltage setting and the display will show
I-set.
3.
You can key in the desired current setting now, if you do not want to change the current setting, you still need to press
ENTER
again
to confirm the new settings of voltage and current to complete the operation.
4.
You must press the
ENTER
key 3 times in total even if you want to change the voltage, otherwise the unit will flash
CANCEL
and returns to its old settings
Note :
If during any of the above keypad operations, you fall to input a setting within 10 seconds, the unit will cancel the procedure and resume its previous
settings. You can exit any of the above operations by pressing the
CLEAR
key and the unit will revert to its previous settings.