8808 User Guide
(BB0339-M)
3D Imaging
17
3D Imaging
3D imaging with the 8808 may be carried out in either of two ways:
•
Freehand – where the transducer is combined with the appropriate 3D system
software.
•
Using mover support – where the transducer is combined with the appropriate
3D system software, the Magnetic Wheel Mover UA0513 and the Variable
Friction Arm UA0553.
Magnetic Wheel Mover UA0513
Further information about the Magnetic Wheel Mover UA0513 can be found in the
user guide for the Magnetic Wheel Mover.
Variable Friction Support Arm UA0553
Further information about the Variable Friction Support Arm UA0553 can be found
in the user guide for the Variable Friction Support Arm.
Disposal
When the transducer is scrapped at the end of its life, national rules for the relevant
material in each individual land must be followed. Within the EU, when you discard
the transducer, you must send it to appropriate facilities for recovery and recycling.
See the applicable system user guide for further details.
Caution:
Do not stick anything into the water inlet to clean it. Poking something into this hole
can damage the water channel inside the transducer. You can clean the water channel by
flushing it with water soon after use, before any foreign matter such as imaging gel has a
chance to harden.
WARNING
For contaminated disposals such as transducer covers or needle guides, follow disposal
control policies established for your office, department or hospital.
WARNING
For contaminated disposals such as transducer covers or needle guides, follow disposal
control policies established for your office, department or hospital.
