
9
NOTE: Maximum recommended starts should not exceed 10 times per hour
.
STOPPING
To stop the pump (manual and automatic mode),turn the pump off at the control, turn off
the breaker, and/or turn the power source off (generator).
CONTROL PANELS CONNECTION OPTIONS
Use with approved motor control that matches motor input in full
load amperes. “UTILLISER UN DÉMARREAR APPROUVÉ CONVENANT AU
COURANT Á PLEINE CHARGE DU MOTEUR.”
BJM Pumps has been evaluated for use with water or water based solutions. Please
contact the manufacturer for additional information.
SINGLE PHASE WIRING INSTRUCTIONS
FOR YOUR PROTECTION, ALWAYS DISCONNECT PUMP
FROM ITS POWER SOURCE BEFORE HANDLING.
Single phase pumps are supplied
with a three prong grounded plug to help protect you against the possibility of electrical
shock.
DO NOT UNDER ANY CIRCUMSTANCES REMOVE THE GROUND PIN.
The
three prong plug
must
be inserted into a mating three prong grounded receptacle.
IF
the installation does not have such a receptacle it must be changed to the proper type,
wired and grounded in accordance with the National Electrical Code and all applicable
local codes and ordinances.
“Risk of electrical shock”
Do not remove power supply cable and
strain relief or connect conduit directly to the pump.
Installation and checking of electrical circuits and hardware should
be performed by a qualified licensed electrician.
Summary of Contents for SV1500CF
