Rev. 1.01
- 11 -
SRP-Q300/302
4. Factory Reset (Printer only)
This function changes the LAN/WLAN settings of the printer to the initial factory settings.
Method
After the printer has finished booting, open the printer cover and press and hold the FEED
button for 5 seconds. This will cause the internal buzzer to buzz 5 times and enter the
interface setting confirmation mode. Then add the paper, close the cover, and check that
the following message is printed.
If the above message is printed, select Mode 2, and you will see the following LAN
information. (To select Mode 2, press the Feed button twice quickly / once long.)
* For models not supported by WLAN,numbers 3 and 4 will not be printed.
Checking Interface Setting
0: Exit
1: LAN Information Print
2: LAN Factory Reset and Reboot Printer
3: WLAN Information Print
4: WLAN Factory Reset and Reboot Printer
5 or more: None
Select Modes by Feed button control
as below.
Step 1. Short-press as many times as
The mode number to choose.
Step 2. Long-press over 1 second.
*e.g. To choose Mode 2, press Feed
Button 3 times(short-short-long)
COVER OPEN LEVER
FEED BUTTON
