Rev. 1.01
- 23 -
SRP-275III
• Function
- Memory Switch 0
Bit
Function
0
1
F~C
Reserved
Fixed to Off
B~A
Red and Black
(inverted black and white) Commands (*3)
Refer to the following table
9~5
Reserved
4
Country Specifications (*1)
SBCS
(Single Byte countries)
DBCS
(Double Byte countries)
3~2
<FF> Command (*2)
Refer to the following table
1~0
Reserved
Fixed to Off
NOTES
(*1) Country Specifications
Country
MSW 0-4 = 0
MSW 0-4 = 1
Overseas
Standard Specifications
Chinese Characters
(*2) <FF> Command Function Selection
MSW 0-3
MSW 0-2
<FF> Command Function
<FF> Command Function
Auto cutter model
Tear Bar Model (SRP-275IIIA type)
0
0
Executes a form feed.
Executes a form feed.
0
1
After paper fed to cutting position
executes partial cut (*3)
Paper fed to the tear-bar position
1
0
Executes a form feed.
Executes a form feed.
1
1
After paper fed to cutting position
executes partial cut (*3)
Paper fed to the tear-bar position
(*3) Red and Black (inverted black and white) Commands
MSW 0-B
MSW 0-A
<ESC> 4 / <ESC> 5 Command Functions
0
0
White/black inverted printing (1 Pass)
0
1
<Option 1> White/black inversion (7 × 9 font print) + enhancing (2 passes)
1
0
<Option 2> Upper line + Und enhancing (2 passes)
1
1
<Option 3> Upper line + Und double tall ex enhancing (4 passes)
This setting functions to specify adornments when the subsequent red (white/black
inversion) print command is set. It is a substitute function for the conventional red/black
(white/black inversion) printing.
<ESC> “4”: Red (white/black inversion) printing
<ESC> “5”: Red (white/black inversion) printing cancelled.
When using <ESC> 5 to cancel adornments, it returns to the previously set adornments.
(Adornments such as underline, upper line, double-tall expanded and enhancing are
cancelled if there is no command to set them (for example the <ESC> “-” 1 specification
for underlines).)
This setting is enabled only for ANK characters and block characters. It is disabled for IBM
block characters and Chinese characters composed of 12 dot vertical characters (IBM
block characters and Chinese characters do not have adornment with this command).
