Connect the Handset Cord
1. Plug one end of the coiled handset cord into
the jack on the handset.
2. Plug the other end of the handset cord into the
jack marked
HANDSET
on the underside of the
UNO.
3. Insert the cable into the channel on the
underside of the UNO so the cable emerges
out the side of the unit.
Connect the Line Cord
1. Plug one end of the supplied line cord into a
wall-mounted telephone jack.
2. Plug the other end of line cord into the jack
labeled
LINE
on the underside of the UNO.
3. Insert the cable into the channel on the
underside of the UNO so the cable emerges
out the back of the unit.
USING YOUR UNO
To Place a Call
1. Pick up the handset, or press SPEAKER, and
dial a number on the dial pad, or
2. Pick up the handset, or press SPEAKER, and
press the desired speed dial keys on the right
hand side of the UNO.
2. Locate the multi-conductor connecting cable
on the underside of the UNO. Taking care to
align the connector correctly, plug the
connector on the cable into the multi-pin jack
on the base unit securely.
Programming the Speed Dial Keys
To program the speed dial keys, follow these steps
below.
NOTE: Make sure that the phone is in an “on-hook”
state (not active, with handset in the cradle, and
speakerphone not engaged).
1. Press the HOLD key.
2. Enter the phone number or dial string to be
saved to memory.
3. Press the HOLD key again.
4. Press the speed dial key to be programmed.
To insert a pause into a number or dial string, press
REDIAL during this process.
This completes the programming procedure for
this key. To program additional speed dial keys,
repeate the procedure as above.
Programming the Flash Duration
CAUTION: Do not make changes to Flash duration
unless you are certain that this is required. Only
change Flash duration if required for proper PBX
interaction with UNO.
Standard Flash duration is 600 ms.
1. Press the HOLD key.
2. Depending on the desired Flash duration, press
the corresponding key as referenced here:
1 – 100 ms
7 – 700 ms
2 – 200 ms
8 – 800 ms
3 – 300 ms
9 – 900 ms
4 – 400 ms
0 – 1000 ms
5 – 500 ms
* – 1100 ms
6 – 600 ms
# – 1200 ms
(In other words, pressing the “3” key will
program the Flash for a 300 ms duration, etc.)
3. Press the HOLD key.
4. Press the FLASH key.
Flash is now programmed to the duration selected.
