USER MANUAL
The common parameters in Standard and User modes
The following parameters apply to both operating modes of the Bitstream 3X, such that a change in
one of these parameters will take effect no matter which mode is being used.
Selection of MIDI and USB Outputs
This parameter allows the user to define from which outputs the
MIDI events are generated
The different choices are as follows:
Send to Midi out 1
Send to Midi out 2
Send to USB out
Note 1: This parameter is configured independently for each control of the Bitstream 3X
Note 2: If a MIDI message should be sent from USB Out 2, the user should configure the two
parameters MIDI out 2 and USB Out from ON
Note 3: After a factory reset, all the available outputs are enabled for each control of the Bitstream 3X.
“Auto-send”
This parameter indicates if the control concerned should be sent
from the MIDI outputs during the booting up of the Bitstream 3X.
This function is generally used to automatically configure the software or the controlled synth, in effect
the values of the controls concerned are sent during the booting up of the Bitstream 3X, also, the
software or the synth controlled positions it’s different controls in the same way as the on the Bitstream
3X
Note 1: This parameter is configured independently for each control of the Bitstream 3X
Note 2: The default auto send value is disabled for all controls
Exclusion of a control of scene memories
This parameter allows the exclusion of a control of the Bitstream
3X from the functions of scene memories. Once this parameter is
ON, the corresponding control won’t be saved or recalled during the usage
of scene memories.
This function is generally used to avoid modifying the value of certain controls while using the scene
memory function.
Note 1: This parameter is configured independently for each control of the Bitstream 3X
Note 2: The default value is disabled for all controls
Rev 1.1 - Page
27
Standard
√
User
√
Outputs
Standard
√
User
√
Auto-send
Standard
√
User
√
Scene exclude