V2
P 5
SPEED
MODE
COLOR
---Product Warranty Rules---
The warranty will be void if any of the situations below
happen.
【
CPU Water Block
】
- The CPU block and the screws in it has any trace of disassemble.
- The top plate inlet and outlet ports, due to improper use of
external forces, are cracked.
【
Radiator
】
- The fin of the radiator are broken or deformed due to improper
use of external forces.
- The inlet and outlet of the radiator are cracked due to improper
use of external forces.
【
Fitting
】
- There are signs of damage caused by instrument clamping on the
fittings.
【
PUMP
】
- Pump damage from pump operation without any liquid.
- Pump damage caused by water leak on the pump's PCB.
- Water tank has been separated from the pump.
【
Fan
】
- Fan damaged by water leak.
1.Introduction
The TA-CARGBMC is an RGB controller which is designed
for LED lights with color selection. When used for the
water cooling system, it can help you to set your person
-
al style.
2.Product Specifications
Color：White
Size：12x49mm
Input voltage：12V~24V
Working current：<3*2A
Max output power：<72W
Operating temperature：<70ºC
Input：Big four pin
Connection Socket：Small Four Pin
Function keys： Speed Mode Color
3.Functional Description
Speed key：
Adjusts the brightness and the speed of
the LED lights. Brightness and speed are divided into
five different options.
Mode key：
The mode selection key provides three
primary colors and three kinds of dynamic colorful light
effect options. After pressing the mode key, you can
use the speed key to regulate the speed of the lights.
Color key：
The color key provides three primary
colors and four kinds of colorful static light effect
options. After pressing the color key, you can use the
speed key to regulate the speed of the lights.
Mode+Color key：
By pressing the two function keys
together for one second, the controller will revert to
the original factory settings.
Note
1. If in Off state, press any key to start.
2. In case of a power failure or a normal shut down, the
RGB controller will keep the selected settings once the
power is resumed.
Water
7
TA-CARGBMC INSTRUCTIONS
8
Water filling hole
Choose your desired dye color and mix it with pure distilled water. Pour the water mix into the reservoir via the water filling hole. Once the reservoir is
90% full, turn on the power supply for the pump to run and let the air exit the loop. Turn off the power supply when the reservoir is near empty. Repeat
until all the air has exited the loop. (In order to power the pump only, connect the power switch connector to the 24 pin cable of the power supply. This
will allow the power supply to bypass the motherboard and make the pump work alone.)
Notice:Bitspower recommends that consumers add the Bitspower dye to distilled water or
purified water for their water-cooling liquid. If the consumer chooses different
water-cooling liquids, the resulting impurities may cause peeling of the coating on some
of the hardware, water channels blockage by built-up residue, improper operation of the
water pump, water tank tube breakage, and o-rings deformation leading to leakage.
Any issues related to the use of inappropriate water-cooling liquid will be the responsi
-
bility of the consumer.
Do not turn on the pump if the reservoir is empty.
2
11
12
F
