BITEL FLEX 5100, User Manual

Page: 61 / 63

.
Regulatory Information
FCC compliance Information
This device complies with part 15 of FCC Rules. Operation is subject to the following two
conditions: 1. This device may not cause harmful interference, and 2. This device must accept any
interference received. Including interference that may cause undesired operation.
Information to User
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference to
radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference at his own
expense.
FCC WARNING:
This equipment may generate or use radio frequency energy. Changes or modifications to this
equipment may cause harmful interference unless the modifications are expressly approved in the
instruction manual. The user could lose the authority to operate this equipment if an
unauthorized change or modification is made.
Body-worn Operation
This device was tested for typical body-worn operations with the back of the INDUSTRIAL PDA
POS kept 1.5cm from the body .To maintain compliance with FCC RF exposure compliance
requirements, use only belt-clips, holsters or similar accessories that maintain a 1.5cm separation
distance between the user’s body and the back of the INDUSTRIAL PDA POS, including the
antenna, whether extended or retracted. The use of third-party belt-clips, holsters and similar
accessories should not contain metallic components in its assembly. The use of accessories that
do not satisfy these requirements may not comply with FCC RF exposure composure compliance
requirements, and should be avoided.