Bissell VAC&STEAM 1977E, User Manual

Page: 9 / 24

Maintenance & Care
Cleaning or Replacing the
Vacuum Filter
The key to maximum performance is having a
clean filter. Cleaning the filter after each use will
help your vacuum operate at peak efficiency.
To clean filter:
1.
Turn power off and unplug unit.
2. Remove the dirt container from the unit, as
directed above.
3.
Remove filter and tap firmly against the inside
of a waste container, removing any visible dirt.
4.
Replace filter back into the dirt container
and attach dirt container to the base of the
unit. Slide the lever to your right to lock.
NOTE:
After heavy usage, you may clean the pleated
filter by washing it gently by hand.
Thermal Protector
An internal thermal protector has been
designed into your vacuum to protect it
from overheating. When the thermal protector
activates, the vacuum motor will stop
operating. If this happens:
1.
Turn the cleaner OFF and unplug from
electrical outlet.
2.
Empty dirt container, check filters and
air passages for dirt accumulation.
3. The thermal protector automatically resets
after approximately 2 hours. If the thermal
protector does not reset, visit the website
Replacing the Water Filter
It is recommended to fill your unit with distilled
water only. Periodically check your water filter.
When the green grains turn blue, change your
water filter.
If the filter is not changed at the appropriate
time, calcium deposits may accumulate on the
heater, causing damage or reduced performance.
To replace the filter:
1.
Using the grips on the side of the filter, pull
filter out of the unit.
2. Push filter firmly into the machine until
it’s flush.
WARNING
To reduce the risk of electric shock, turn off machine and
disconnect polarized plug from electrical outlet before
performing maintenance or troubleshooting checks.
2.
www.BISSELL.com
9
Water Filter
WARNING
To reduce the risk of electric shock, turn power switch off
and disconnect polarized plug from electrical outlet before
performing maintenance or troubleshooting checks.