10
BISSELL.com
Maintaining the Pet TurboEraser® Tool
For additional maintenance steps, visit
support.BISSELL.com
.
1.
Twist gray collar counter-
clockwise, until slot appears,
then separate faceplate.
2.
Remove brush roll, belt
and paddle wheel. Inspect
for damages and replace if
necessary.
3.
To reassemble, align two
clips on each end of paddle
wheel with belt on and pop
into place. Place brush roll
with belt back in. Put faceplate
back on by aligning tabs in the
top of the cover and “click”
into place.
Replacing the Brush & Belt
Visit
BISSELL.com
to find replacement parts.
1.
Unplug and turn vacuum
over. Use coin to turn 6 slats to
remove bottom cover.
2.
Pull brush roll straight out
and slide belt off motor gear.
3.
Inspect brush roll by placing
it on its end and spinning.
The brush roll should spin
freely, multiple times by one
flick. If it doesn’t, replace brush
roll. Inspect belt for damages
and replace if necessary.
4.
Place belt back on brush
roll. Hook belt back around the
motor gear.
5.
Reattach bottom cover by
turning 6 slats to tighten.
