for Suction only:
Tilt the unit forward, pressing the front of the
spot lifter Powerbrush firmly against the surface
area to be cleaned, lifting the brushes up off the
surface. Pull toward you to remove the soil and
cleaning solution.
notE: Step #4 may be repeated until no more
dirty water is removed or until the area to be
cleaned meets your satisfaction.
5.
Check the collection tank and empty the tank
if it is full (see To empty the collection tank,
below).
6.
if the spot lifter Powerbrush stops spraying,
turn off the unit and check the cleaning solution
level in the solution tank. Refill if needed. Never
run the unit without water or cleaning solution.
Spot cleaning upholstery
1.
Check manufacturer’s tag before cleaning.
“W” or “Ws” on the tag means you can use your
spot lifter Powerbrush. if tag is coded with an
“s” (with diagonal strike-through) or states “Dry
Clean Only”, do not proceed.
2.
if manufacturer’s tag is missing or not coded,
check with your furniture dealer.
3.
if possible, check upholstery stuffing. Colored
stuffing may bleed through fabric when wet.
Operations
www.bissell.com
800.237.7691
WaRnInG
Keep spray away from face. Failure to do
so may result in personal injury.
ImpoRtant
Check the manufacturer’s tag before
cleaning upholstery. “W” or “WS” on the tag
means you can use your SpotLifter. If tag
is coded with an “S” (with diagonal strike-
through), or says “Dry Clean Only,” do not
proceed. If manufacturer’s tag is missing or
not coded, check with your furniture dealer.
7
machine care
1.
Turn the power switch to the “OFF”
position. ( O )
2.
Unplug the unit.
3.
Carry the spot lifter Powerbrush to the sink
or drain.
to empty the collection tank
1.
begin by removing the solution tank. Gently
press the quick release tabs on the solution tank
and slide the tank off of the unit.
2.
Grasp the collection tank and pull to remove.
3.
While at the sink, remove the tank cap by
unscrewing and lifting out.
4.
empty the tank. Rinse the collection tank with
warm water.
5.
Replace cap by turning to the right, until snug.
6.
slide the collection tank into the unit. Replace
the solution tank.
notE: If a significant amount of water and
formula remains in the solution tank, you
may leave it in the solution tank for your
next cleaning task.
Maintenance & Care
WaRnInG
To reduce the risk of electric shock, turn power switch
off and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.
1.
2.
3.
