10
BISSELL.com
Cleaning the Sensors
Replacing the Battery
WARNING
To reduce the risk of electric shock, turn the Power Switch OFF before performing maintenance or
troubleshooting checks.
After repeated use, debris can accumulate on the sensors
of the robot and the robot’s performance could be affected.
To ensure the best efficiency, the sensors should be cleaned
off periodically by brushing any debris from them.
Turn the Power Switch OFF before cleaning the sensors.
WARNING
This product contains Lithium-Ion rechargeable batteries. DO NOT mix Lithium-Ion
batteries with general household waste. According to Federal and State regulations, removal and proper disposal
of Lithium-Ion batteries is required. For specific battery disposal instructions please contact Call2Recycle at
877-723-1297 or visit www.call2recycle.org.
1.
Turn the Power Switch OFF.
2.
Use a Phillips-head
screwdriver to remove the two
screws and battery cover.
3.
Remove the battery and
disconnect.
4.
Connect the new battery
and install into battery
compartment.
Do not remove
the plastic shrink sleeve from
the battery pack.
5.
Use a Phillips-head
screwdriver to replace the
battery cover.
Note:
Any other servicing should be performed by an authorized service representative.
Sensors and Contacts
1. Cliff Sensors
2. Charging Contact Points
3. Soft Surface Avoidance Sensor
1
3
2
2
1
1