10
BISSELL.com
Storing Your Machine
Once your cleaning is complete, make sure the the 2-in-1 tank and SmartMix® Tank is emptied and
rinsed out. Store in a closet or basement for the next use.
NOTICE
To reduce the risk of a leaking condition, do not store machine where freezing may occur. Damage to internal
components may result.
Problem
Possible Cause
Remedies
Reduced spray
or no spray
Bladder may be empty.
Refill bladder with hot tap water.
Filter may be clogged.
Clean out the flow indicator following steps on
page 8.
Tanks may not be seated
properly.
Turn power OFF (O); remove & reseat tanks.
Pump may have lost prime.
Turn power OFF (O); after 1 minute turn ON and
press trigger.
Pump belt may be broken.
Turn ON the machine and check to see that the
DirtLifter PowerBrush turns.
The 2-in-1 and SmartMix®
Tanks are empty.
Refill tanks according to page 4.
Cleaning mode switch is not
fully on a mode.
Ensure the dial is in the correct position.
DirtLifter®
PowerBrush
does not turn
Brush belt or pump belt is off
or broken.
Turn the machine OFF (O) and unplug from
the outlet. To check if the brush belt or pump
belt has broken, you will need a flathead
screwdriver. Insert the blade end into the lower
slot of the Belt Access Door to release the lower
snap. If necessary, insert the blade end into the
upper slot to release the upper snap.
Examine the belt for breakage. If broken, visit
BISSELL.com for replacement part information.
Reduced
suction or no
suction
ReadyTools™ Dial may be
on the wrong setting for the
cleaning job.
Set ReadyTools™ Dial to the proper setting,
depending on how you are using your machine.
2-in-1 Tank lid is not properly
installed.
Reinstall lid following steps on page 4.
2-in-1 Tank is not properly
seated.
2-in-1 Tank must be firmly seated to function;
remove and reseat tank.
Poor tool position. (Handheld
attachments only.)
Adjust angle; apply more downward pressure.
2-in-1 Tank has picked up
maximum dirty water.
Empty tank following steps on page 8.
WARNING
To reduce the risk of fire, electric shock, or injury, turn power OFF and disconnect plug from
electrical outlet before performing maintenance or troubleshooting.
Troubleshooting
Below are some of the issues you may run into. If you don’t see the issue you’re experiencing
below, visit
support.BISSELL.com
.
