11
1. Follow instructions in WHEN YOU’RE DONE, page 7.
2. Disconnect Solution Tube Connector by turning it counter-
clockwise and gently pulling it straight from port.
3. Remove Flex Hose Assembly from Dirty Water Tank
Triangle port.
4. Replace Dirty Water Tank Triangle Lid.
5. Coil Flex Hose Assembly in Hose Rack on back
of POWERSTEAMER.
TM
6. Rinse Tools in clean running water, dry, and replace as
shown in HOW TO PUT IT TOGETHER, page 4.
7. Wrap Power Cord around Cord Holder on back of
POWERSTEAMER.
TM
8. Wipe all surfaces with a soft cloth.
9. Store cleaner upright in a protected, dry area.
NOTE: You may have water remaining in the Clean Water
Tank Assembly, and BISSELL Fiber Cleansing Formula
TM
remaining in the SmartMix
®
dispenser. Never leave clean
water in the Clean Water Tank Assembly or soiled
solution in the Dirty Water Tank Assembly.
13. Unwrap Power Cord from Cord Retainer and
plug into 120 Volt, 60 Hz grounded outlet as
described in Important Safety Instructions,
page 2.
Cleaning
1. Slowly move the Bare Floor Cleaning Tool
back and forth over soiled surface one time
while depressing Trigger.
Do not overwet.
2. Repeat motion over same area without
depressing Trigger.
3. Repeat Steps 1 and 2 until no more dirt can
be removed.
4. If machine loses suction and/or noise rises in
pitch, turn Power Switch to OFF. Check the
Dirty Water Tank Assembly and empty the
tank if it is full (see WHEN YOU’RE DONE,
page 7).
5. If spray tip stops spraying, turn Power Switch
to OFF and check water and cleaning solution
levels. Refill if needed.
Never run POWERSTEAMER
™
dry.
WARNING:
Do n o t
lay unit on its back with
Clean Water Tank Assembly
in place. Do not tip up
foot with Dirty Wa t e r
Tank Assembly in place.
Putting it away
WARNING:
T h e
D i rt y Wa t e r Ta n k
A s s e m b l y h o l d s
approximately one
gallon of soiled liquid.
A special float device
in the tank will cause
the cleaner to stop
removing solution from
carpet, and the motor
sound to rise in pitch
when the Dirty Wa t e r
Tank Assembly is full.
Failure to empty full
tank will damage unit.
