www.BISSELL.com
Maintenance: Drive Belt
9
With rotating brush removed
(steps 1-3 maintenance floor
brush roll), grasp old drive belt
and remove from motor pulley.
Place new belt over
motor pulley and
stretch other end
over the floor brush.
Place ends of rotating floor
brush down into slots.
Reposition bottom cover and
replace all 6 screws.
Twist top handle from the round
separator counterclockwise to
release. Wash in warm water with
mild detergent. Dry completely
before reassembling.
With the top handle
removed, wash the dirt
tank in warm water
with mild detergent.
Allow tank to air dry.
Align tabs to return
separator to top handle.
Align latch arrows and
twist tank clockwise
until “clicks” into place.
Maintenance: Floor Brush Roll
Clean debris from rotating
floor brush, motor
pulley, drive belt and air
passageway areas.
Grasp rotating floor
brush at both ends and
lift straight out of the
vacuum foot. Slip off
the belt.
Maintenance: Cleaning the Dirt Tank
Ensure vacuum is unplugged.
Place handle in low position,
remove hose from foot and
turn vacuum over bottom side
up. Remove 6 screws with a
Phillips head screwdriver. Lift
brush cover off of the vacuum.
1
1
1
2
2
2
3
3
3
