www.BISSELL.com
5
Operations
Cleaning with hard nozzle
1.
Turn hand vacuum OFF.
2.
Remove flexible rubber nozzle by pressing
down on round nozzle release button.
3.
Replace with hard nozzle by lining up the
bottom of nozzle to the bottom of the dirt
container. Pivot upwards to snap into place.
4.
Make sure the nozzle has snapped securely
into place before using.
Cleaning with flexible rubber contour nozzle
1.
Turn hand vacuum OFF.
2.
Remove hard nozzle by pressing down on
round nozzle release button.
3.
Replace with flexible rubber contour nozzle
by lining up the bottom of nozzle to the bottom
of the dirt container. Pivot upwards until it snaps
into place.
4.
Make sure the nozzle has snapped securely
into place before using
Emptying the dirt container
Empty the dirt container after each use. A
full dirt container may reduce suction or
performance of vacuum.
1.
Turn hand vacuum OFF.
2.
Unplug hand vacuum from electrical outlet.
3.
Press dirt container release latch down to
disconnect dirt container and filter assembly
from the unit.
4.
Remove filter by grasping tabs on both
sides of filter frame and pulling away
from the dirt container. For best results,
periodically tap filter assembly against
trash can to remove dirt that has collected on
the screen and filter.
5.
Empty dirt into trash can.
6.
Replace filter assembly by aligning side
labeled “TOP” into top of dirt container. Grasp
filter tabs and press firmly to ensure filter
assembly is secure in dirt container.
NOTE: Make sure side of filter assembly labeled
“TOP” faces outward when inserting filter
assembly into dirt container.
7.
Reattach dirt container to unit by aligning
bottom of dirt container to bottom of unit. Pivot
upwards and snap into place. Use one hand to
hold the unit and use the other hand to clip the
dirt container securely in place.
WARNING
Do not operate cleaner with damp or wet filters
or without vacuum bags and all filters in place.
2.
3.
3.
2.
3.
4.
5.
6.
7.
