Checking rotating floor
brush and drive belt
Check your vacuum’s rotating floor brush
and drive belt regularly for wear or damage.
1.
Turn power OFF. Unplug vacuum cord
from electrical outlet.
2.
Place handle in low position and turn
vacuum over so bottom side is facing up.
3.
Using a screwdriver, remove the six
screws and lift brush cover off.
4.
Grasp rotating floor brush at both ends
and lift.
5.
Clean strings, hair and other debris from
rotating floor brush, motor pulley, and drive
belt areas.
6.
Check drive belt for wear, cuts, or
stressed areas.
7.
Check air passageway for obstructions.
Remove debris from this area.
8.
Place drive belt back onto motor pulley and
brush roll. Put right side brush roll end cap back
into the housing. Pull on the brush roll applying
tension to the drive belt. Put left side end cap
back in the housing.
9.
Reposition brush cover and fasten six
screws back into place.
Maintenance & Care
www.BISSELL.com
10
3.
4.
7.
motor
pulley
air
passageway
