16
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
Cleaning the inner & outer circular filters
Use only BISSELL Style 12 replacement filters in
your BISSELL PowerForce Turbo Bagless.
1.
Unplug the cleaner from electrical outlet.
2.
Remove the dirt container as described in
the previous section. Grasp the filter cup
located at the bottom of the dirt container
and twist counterclockwise to unlock and
remove.
3.
Grasp the circular filters and pull straight up
to remove.
4.
Separate the outer foam and inner pleated
circular filters. Wash each individually by
hand in warm water. Mild detergent may be
used if desired. Rinse well, then air dry
thoroughly before putting them back
together and replacing in filter cup.
5.
The filter cup may be washed in warm water
with a mild detergent. Make sure it is completely
dry before reassembling with filters.
6.
The upper tank and primary separator may
also be wiped clean with a damp cloth.
Reach underneath the upper tank and turn
the rim of the primary separator to unlock.
Pull straight down to remove.
Cleaning pre-motor filter
1.
Unplug the cleaner from electrical outlet.
2.
The pre-motor filter protects the motor from
debris. It is located underneath the dirt
container and filter cup in the center of the
round part of the Lock ‘n Seal lever.
3.
Remove the small round filter and any debris on
top of it. Rinse well under warm water, then air
dry thoroughly before replacing.
M
aintenance and care
9
WARNING:
Do not operate cleaner
with damp or wet
filters or without all
filters in place.
Pre-Motor
Filter
ug110_4018_6585_1207.indd 9
ug110_4018_6585_1207.indd 9
12/19/07 10:04:56 AM
12/19/07 10:04:56 AM
