w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
A
ssembly
6
5.
Make sure that crevice tool is inside the
extension wand. Store the extension wand
and crevice tool on the back of the unit.
Place tools on the extension wand support
and push toward the back of the unit until
clip holds tools in place.
6.
Slide the dusting brush into the storage
clip on the left side of the unit (when
viewing from back.)
7.
Place the TurboBrush Tool in the hole
marked “tool” on the top of the handle arch.
handle positions
using your foot, press the handle
release pedal, located on the lower
left side of the vacuum, to recline
the vacuum.
transporting your cleaner
1.
To move your cleaner from room to room,
put the handle in the upright position, tilt
the cleaner back on its rear wheels and
push forward.
2.
The cleaner can also be moved by using
the carry handle on the front.
power cord
to store power cord, wrap cord around
the upper cord wrap and lower extension
wand support. once wound tightly use
the clip on the end of the plug to attach
the plug to the cord.
to release the power cord, rotate the upper
cord wrap down and gently pull the power
cord off of the upper cord wrap.
power switch
the power button is located on the left
side (when viewing from back) of the
vacuum. push the rocker switch “on”
(i) to vacuum, and “off” (o) when
cleaning is complete.
note: the rotating brush will not
turn on unless the unit is in the
reclined position and the brush
switch is on.
attach storage clips, tool, and vacuum hose continued
Crevice Tool
Extension
Wand
Stretch Hose
Dusting/
Upholstery
Tool
TurboBrush
®
Tool
1
2
Power Switch
caution:
Before using your vacuum,
Make sure both filters
(pre-motor and post-motor)
are in place. Do not operate
your vacuum without these
filters.
O
perations
