www.bissell.com
5
A
Product View
b. Hard floor tool
The hard floor tool is equipped to clean
hard floor surfaces such as wood, tile, and
laminate. This tool is ideal for removing fine
dirt and debris on hard flooring.
note: the roller brush will only rotate on
hard floor surfaces. it can be used to clean
carpet, but the brush will not rotate.
c. carpet tool
Multi-surface brush switch has retractable
brushes to clean both carpet and hardwood
floor surfaces.
vacuum carpeted areas
set the multi-surface brush switch to the
carpet position (brushes should retract).
vacuum Hard surfaces
set the multi-surface brush switch to
the hard floor position (brushes should
be visible).
d. storage
There are two storage options for your
Hard Floor expert:
1.
locate the groove behind the machine
and connect the floor tool to the base
or
2.
locate the groove on the backside of the
canister and connect the telescopic wand.
D
Operations
1.
locate the power cord on the back of
the unit and plug in.
note: the power cord can be pulled out
until the yellow mark is visible. do not pull
out past the red mark on the cord.
2.
Turn on the vacuum by pressing the
power button on the base of the canister.
3.
When the dust cup reaches the MAX line,
turn off the machine and remove the dust
cup from the base of the machine, by
opening the lid and pulling up
4.
To empty, locate the yellow tab that says
“push” and push to empty
5.
if the yellow cyclone is dirty, it can be
removed by rotating it counter clockwise
and pulling out. Clean as needed before
replacing.
6.
Reassemble the dust cup after cleaning.
7.
When cleaning is complete. Power off
the vacuum by pressing the power button
on the base of the canister.
8.
Unplug the vacuum from the electrical
outlet.
B
Assembly
You do not need any tools to assemble your
vacuum cleaner.
1.
Connect the hose to the canister body.
Once it snaps, it is in place.
a.
To disconnect the hose, squeeze the
snaps located on the side of the hose
connection and pull out
2.
Connect the handle to the telescopic wand.
3.
Connect the desired floor brush to the end
of the telescopic wand.
4.
Place the dusting brush and crevice tool
in place on the telescopic handle.
a.
Dusting tool
b.
Crevice tool
C
Special Features
a. variable suction
The Hard Floor expert is equipped with
variable suction to easily go from cleaning
carpets and hard floors to delicate surfaces
like drapes and upholstery.
To increase suction power, slide the dial
(on the base of the canister) towards the
“+” sign. To dial down the suction, slide
the dial towards the “-” sign.
Do not plug in your cleaner until you have
completely assembled it per the following
instructions and are familiar with all instructions
and operating procedures.
Be careful to avoid injury as cord retracts very quickly.
Plastic film can be dangerous. To avoid danger of
suffocation, keep away from babies and children.
Before using your vacuum, make sure that the dirt
cup and all filters are in place. Do not operate your
vacuum without the dirt cup and filters.
1 Hose Connector
2 Front Cover
3 Dust Bin (beneath cover)
4 Big Wheel
5 Variable Suction Controls
6 Rewind Button
7 Power Button
8 Carry Handle
9 Power Cord
10 Filter
11 Carpet Tool
12 Hard Floor Tool
13 Telescopic Wand
14 Crevice Tool
15 Dusting Brush
16 Handle/Hose
