BISSELL Confidential
D) CHECK TO SEE IF MACHINE LOST PRIME.
Turn power off and back on. Wait one minute then depress trigger.
E) IS THE PUMP-TO-MOTOR BELT STILL INTACT?
If this belt is broken, the pump will not work. Replace belt if broken.
F) CHECK TO SEE IF SPRAY THRU HOSE:
If YES, machine sprays thru hose
►
Pump is good, proceed to next step to check for spray to
floor
If NO spray thru hose
►
Remove the tool on the end of the hose and see if hose will
spray. If the hose sprays when the attachment is not
connected, then the tool is clogged. Advise consumer to
try cleaning out the spray-tip on the tool with a paper
clip. The tool may require replacement.
►
Stretch the hose out and give it a few light tugs to release
any kinks in the internal water supply hose.
*Proceed once they verify it will spray through hose.
If still no spray to the hose refer to nearest ASC.
G) RE-ATTACH THE HANDLE:
If other steps fail to fix the problem, ask the consumer to remove the
handle completely and re-attach. Once the handle is re-attached re-
attempt to spray.
If still no spray:
Please take the machine to an AUTHORIZED Service Center; or issue RA if
under warranty and service center too far away
.
A) CHECK TO SEE IF MACHINE LOST PRIME.
Turn power off and back on. Wait one minute then depress trigger.
B)
CHECK ATTACHMENTS AND HOSE
Remove the tool on the end of the hose and see if hose will spray.
If the hose sprays when the attachment is not connected, then the
tool is clogged. Advise consumer to try cleaning out the spray-tip on
the tool with a paper clip. The tool may require replacement.
Stretch the hose out and give it a few light tugs to release any kinks
in the internal water supply hose.
No Spray thru hose, but sprays at floor
