www.BISSELL.com
7
4
5
1
3
Select cleaning mode:
To start cleaning your hard floors, turn the
machine ON by pressing the
HARD FLOOR
Button
or
RUG
Button. Once the setting is selected, the
dry vacuum will turn ON. To turn OFF, press the
HARD FLOOR
Button or
RUG
Button a second
time.
Area Rug Mode dispenses twice as much solution
as Hard Floor Mode. Before cleaning area
rugs, check the manufacturer’s tag and test an
inconspicuous spot on the rug for colorfastness.
Do not use on silk or delicate rugs.
Before each use, hold the Solution Spray
Trigger for 10 seconds to prime the
system with cleaning solution. LED lights
illuminate when holding the trigger.
NOTE:
When solution is flowing, you will
see bubbles forming at the edges of the
Brush Roll Window.
To clean, hold the Solution Spray Trigger
to apply solution on both forward and
backward passes.
To dry floors faster, release the trigger
and clean a second pass without
dispensing solution.
TIP:
When cleaning excessively dirty or muddy hard floors, or if your Brush Roll
looks dirty, use the 3-in-1 Docking Station to rinse your Brush Roll before cleaning
your area rugs.
2
Recline the Body of the machine
backward to start the Brush Roll spinning.
To stop the Brush Roll spinning, you will
need to stand the machine upright.
TIP:
For overly challenging and stuck-on messes on your hard floors, activate the RUG
mode and hold your CrossWave® Cordless over the mess. Using short passes while
holding the trigger allows the multi-surface brush to go to work.
Cleaning Your Floors
ATTENTION
Do not overwet carpet. Be careful not to run over loose objects or edges of
area rugs. Stalling the brush may result in premature belt failure.
