global.BISSELL.com
5
ATTENTION
Do not overwet carpet or hardwood floors. Be careful not to run over loose objects or edges of area
rugs. Stalling the brush may result in premature belt failure.
1.
Press the button on top of
the tank, grab the front handle
and pull the tank out.
2.
Hold the top of the tank
near the sides of the filter and
pull up to remove.
3.
Pour dirty water down the
sink and rinse the tank.
Emptying the Dirty Water Tank
Cleaning Your Floors (continued)
4.
Hold the trigger to apply
solution on forward and
backward passes. For tough
messes, hold the machine over
the mess and use short passes.
5.
Release the trigger and
make a backward pass without
dispensing solution. To dry
floors faster, make additional
dry passes.
6.
Press the power standby
button to put the machine in
standby mode.
Press power switch on back of
machine to OFF position.
1.
With machine in standby
mode and in the upright
position, press the self-clean
button. The dirty water tank
indicator will flash 5 times and
then turn solid amber. This is
a reminder to empty the dirty
water tank.
2.
Press the self-clean button
again. The machine will run
two cycles:
15 second wash cycle:
LED
lights on foot turn ON. Solution
will flow on brush roll.
45 second dry cycle:
LED
lights on foot turn OFF. No
solution flowing on brush roll.
3.
Machine will shut off when
self-cleaning is complete.
Repeat as necessary. Empty
dirty water tank when finished.
Using the Self-Clean Cycle
