w w w. b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
M
aintenance and care
10
Cleaning the pre-motor filter
1.
unplug the cleaner from electrical outlet.
2.
the pre-motor filter protects the motor from
debris. it is located underneath the filter cup
in the center of the round part of the
lock ‘n seal™ lever.
3.
Remove the small round filter and any debris
on top of it. Rinse well under warm water, then
air dry thoroughly before replacing.
Replacing the post-motor filter
Use only genuine BISSELL style 9
(#32076) replacement filters in your
BISSELL CleanView Helix.
1.
unplug the cleaner from electrical outlet.
2.
the post-motor filter assists in the filtration
process to return clean air to the room. it is
located behind the door on the side of the
vacuum. When the filter becomes dirty,
open the door, remove the filter and replace.
the white, pleated post-motor filter is not
washable and must be replaced.
Note: A basic washable
post-motor filter with reduced
filtration is available if desired.
You should check your vacuum clean-
er’s rotating floor brush and drive belt
regularly for wear or damage. You
should also clean the brush and brush
ends of strings, hair and carpet fibers.
These can wrap around the brush and
hamper its ability to effectively clean
your carpet. Also remove any debris
that has accumulated under the
brush cover.
1.
unplug cleaner from electrical outlet.
2.
place handle in low position and turn
vacuum cleaner over so bottom side is up.
3.
Remove the five screws with a phillips
head screwdriver. lift the brush cover off.
4.
grasp rotating floor brush at both ends and lift.
Post-Motor
Filter
WARNING:
Do not operate cleaner
with damp or wet filters or
without all filters in place.
WARNING:
To reduce the risk of injury from
moving parts, turn off vacuum
cleaner and disconnect Power
Plug from electrical outlet.
Pre-Motor
Filter
Motor Pulley
4.
Checking rotating floor brush and drive belt
3.
Brush Cover
