6
BISSELL.com
Maintaining the Pet TurboEraser® Tool
Go to
support.BISSELL.com
for additional accessories and replacement tools.
1.
Twist gray collar counter-
clockwise, until slot appears,
then separate faceplate.
2.
Remove brush roll, belt
and paddle wheel. Inspect
for damages and replace if
necessary.
3.
To reassemble, align two
clips on each end of paddle
wheel with Belt on and pop
back into place. Place brush roll
with belt back in. Faceplate will
not close properly if all parts
are not aligned correctly.
4.
To put faceplate back on,
align the tabs in the top of the
cover and place it down to
“click” into place.
Cleaning & Replacing the Filter
Go to
support.BISSELL.com
for tips on maintaining and replacing your vacuum filter.
1.
For best cleaning
performance, always clean
your filter after each use. Turn
machine OFF. Remove dirt tank
by pressing the tank release
button and sliding the tank out.
2.
Twist top to remove filter
frame from the separator.
Remove the filter from the
filter frame housing. Tap the
filter against the side of a trash
bin to remove dust and debris.
3.
Rinse under warm water
and squeeze to remove dirt.
Lay out for 24 hours until
completely dry. Reinsert filter
into the frame with the tag side
touching the frame.
WARNING
Before using your vacuum, make sure that the dirt tank is in locked position and that the filter is in
place. DO NOT operate your vacuum without the filter.
