www.BISSELL.com
10
www.BISSELL.com
11
Empty Dirty Water Tank
WARNING
To reduce the risk of fire, electric shock or injury, turn power OFF and disconnect from
charger before performing maintenance or troubleshooting.
Clean the Nozzle
WARNING
To reduce the risk of fire, electric shock or injury, turn power OFF and disconnect from
charger before performing maintenance or troubleshooting.
Carefully remove the Dirty Water Tank from
the unit and carry to a sink. To prevent
spills, hold tank vertically after removing.
To empty, pull tab at the end of the tank
and empty to remove the dirty water.
Ensure the unit is OFF and set upright
on a flat surface. Simply push up on the
release button located on the top of the
tank to remove.
1
4
Rinse out the Dirty Water Tank with
clean water after emptying.
Close the tank plug
and return tank to
the unit. Ensure
the tank is secure
before use.
2
3
Rinse Nozzle with clean
water and check spray
nozzle for dirt or debris.
The front nozzle of the unit removes for easy
cleaning of dirt and debris. Remove the Clean Water
Tank and locate the latch at the top of the nozzle.
Pull tab and rotate back to separate from unit.
If necessary, wipe with a clean
cloth or soft bristle brush.
Replace the front Nozzle by hooking lower edge
onto unit and snapping into place. Then place the
Clean Water Tank back on the unit.
2
3
NOTICE:
To reduce the risk of a leaking condition, do not store where freezing
may occur. Damage to internal components may result.
click
click
4
1
click
NOTICE:
Ensure Nozzle clicks into place and that it’s properly installed prior to
replacing the Clean Water Tank. If Nozzle does not click, then the seal isn’t made
and will significantly reduce suction.
