2
C
D
E
D
3. Install Rim Removal Bushing on rim by
inserting the
Rim Removal Bushing
(C) thru
the 3/4” hole in the top of the rim. Fasten it
tightly with the
3/4” External Tooth Lock
Washer
(D) and the
3/4” Jam Nut
(E).
(Figure 3)
Warning!!!
Rim Removal Bushing (Item C) must be
as tight as possible to prevent injury
when removing the rim.
Required for TR95, TR96
4. Assemble Removal Pole by inserting the
Top
Pole
(J) into the
Bottom Pole
(K) until both 1/4”
holes align. Insert a
1/4” Roll Pin
(I) into each
hole and tap lightly with a hammer until the Roll
Pin is flush with the surface of the Bottom Pole.
(Figure 4)
K
I
J
Figure 3
Figure 4
Note:
Use Caution inserting Roll Pins.
Do not bend as alignment of holes
in Removal Pole is critical!
