Bison Centerline Volleyball SVB1000, Instruction Manual

Page: 6 / 7

6
Nets at Different Heights
1. Remove tension from both nets with the Winches (H).
2. Attach one of the Nylon Net Collars (J) provided in the hardware kits to the center standard towards the top
See Figure 5.
3. Loosen the Knurled Knobs (M) and remove the Positive Lock Pins (Q) of all three poles, adjust the net that
will be at the greater height, then retighten those two poles. See Figure 1.
4. Adjust the Nylon Net Collar (J) on the center pole to the desired height for the second court and tighten.
5. Adjust the lower net court winch pole and tighten the Winch (H). See Figure 5.
6. Reattach and tension both bottom ropes.
7. Attach all Rope Ratchets (N) per previous instructions.
8. On multiple side by side court systems, the Winch (H) on the court adder poles should be placed above the
collars so web strap will not interfere with bottom rope attachment.
1. If you have purchased the Bison VB10/20 3” Standards (A), for use in existing sockets that are not 3”
diameter call Bison Customer Service department at 1 - 800 - 247 - 7668 for custom floor socket sleeves
available at no additional cost.
2. You will need to provide the inside diameter of the floor socket and the depth of the socket from the playing
surface to the bottom.
3. If the Adapter Sleeves fit loosely in the floor sockets they can be shimmed with thin metal strips or
layers of duct tape can be wrapped around the outside of the sleeve at the top and the bottom until sleeve is
snug inside the existing floor sockets.
4 If your pre - existing floor sockets are more than 12” deep from the finished floor to the bottom of the
socket, call the Bison customer service department at 1 - 800 - 247 - 7668 for information on the VB10/20
Deep Socket Adapter Kits available at no additional cost.
Custom Floor Socket Sleeves & Deep Socket Adapters
Height Adjustment for a Side by Side Court System cont.
37' CENTER TO CENTER
(29'-6" 2 ON 2 SAND)
37' CENTER TO CENTER
(29'-6" 2 ON 2 SAND)
Figure 5