4
1.
Starting with a loose top net cable, loosen the
Knurled Knobs
(M), remove the
Positive Lock Pins
(Q)
and
adjust the inner poles to the desired height indicated by the height markings machined on the inner poles
and then tighten the
Knurled Knobs
(M) and if you are adjusting to one of the official heights marked on
the poles you can reinsert the positive lock pin. See Figure 1.
2. Adjust
Nylon Net Collars
(J) so that they are
2”
-
3”
below the bottom of the net.
3.
Crank top rope tight with the
Winch
(H), then pull bottom rope tight through the
Rope Ratchet
(R).
4.
Attach Rope Ratchet Net Tensioning Ropes around pole and hook ends together, then center the net
between poles as in previous instructions and apply desired tension. See Figures 2 & 3.
Height Adjustment for a Single Court System
NOTE :
Excessive tightening of top rope is not necessary. Crank the winch until poles start to flex.
Further tensioning results in lowering of the top rope. Achieve proper height using the inner pole
adjustment and to achieve proper net tensioning use the rope ratchets.
NOTE :
Excessive tightening of top rope is not necessary. Crank the winch until poles start to flex. Further
tensioning results in lowering of the top rope. Achieve proper height using the inner pole adjustment and to
achieve proper net tensioning use the rope ratchets.
TIGHTEN ROPE RATCHET
TENSIONERS SO THAT NET IS
CENTERED BETWEEN THE POLES
APPROX.
42"
CARABINEER (K)
WINCH (H)
Bottom Rope
Ratchet (R)
37' CENTER TO CENTER
29'-6" 2 ON 2 SAND
Figure 3
Summary of Contents for Centerline Volleyball SVB1000
Page 7: ...7 Court Diagram...
